Mori Seiki SH-40
High-efficiency, Super-precise
Horizontal Machining Center

• Maximum spindle speed: 12,000 min^-1
• Rapid traverse rate: 32 m/min (1,260 ipm)
• ATC time: 1.5 sec* (tool-to-tool)
• Tool magazine storage capacity: 40 [60, 120, 180] tools
• Working surface: 400 x 400 mm (15.7 x 15.7 in.)
• Spindle drive motor<15 min/cont>: 22/18.5 kW(30/24.8 HP)

        *At 60Hz

• Chip conveyor inside machine (Spiral type)
• Coolant system
• Shower coolant
• Oil-hole drill coolant system
• Air blow system
• Oil cooler
• 2-station turn type APC
• Look ahead control
• Automatic power-off system
• Signal indicator
• Built-in worklight
• Position block for tooling
• Leveling block
• Hand tools
  
  
  Safety Features
• Full cover (incl. ceiling cover)
• Door interlock system (incl. mechanical lock)
  • Right side door/Magazine door/Setup station door
• Door interlock system
  • Electric cabinet
• Low hydraulic pressure detecting switch
• Low air pressure detecting switch

• 3-station turn-type
• Auto-coupler for fixture clamp (hydraulic/pneumatic)
• 64-bit RISC
• Direct scale feedback
• Contact type sensor (probe sensor)
  • Automatic measurement
  • Automatic centering
• Contact type sensor (table mount)
  • Automatic tool length measurement
  • Automatic tool breakage detection
• High-pressure coolant system (6.9MPa)
• Through-spindle coolant system (center/side)
• Oil shot system
• Oil mist system
• Oil skimmer
• Chip conveyor outside machine (hinge type/scraper type)
• Coolant gun
• Mist collector
• Dust collector
• 6-station pallet pool
• 8-station pallet-pool
• Linear pallet pool
• Conversational programming unit (10.4 inch LCD)
• Load monitor
• Work counter
• Total counter
• Auto-extinuisher interface
• Earth leakage breaker

Note:

- Some options are not available in particular regions. For details contact Mori Seiki.
- Specifications, accessories, safety devices, and functions are available upon request.
- Figures in inches are converted from metric measurements.
- Design and specifications subject to change without notice.
- Mori Seiki is not responsible for differences between the information in the catalog and the actual machine.

E-Mail Hannah Engineering